Collada2POD from Sketchup

This topic contains 0 replies, has 1 voice, and was last updated by  jem 6 years, 7 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #30480

    jem
    Member

    Hello,

    I need help with Collada2POD: My model almost fully disappears during the conversion.

    Using Sketchup, I export my simple model (see below) to collada format, then configure Collada2POD using the following settings (suggested on Cocos3D wiki) to perform the conversion:
    http://brenwill.com/wp-content/uploads/Collada2POD.png

    My sketchup model is available here

    Can someone please look into this? I’ve run out of clues to solve this Dead

    Thanks!
    J

Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.