- March 11, 2013 at 12:41 pm #31180
How to port Free RTOS on HTP 221 ( MInimorph )
Plz help 🙂
SaurabhMarch 12, 2013 at 10:17 am #36808
Welcome. Hope you don’t mind but I have a few questions so we can best help you.
Are you doing this as part of a project or is this for your own interest? Do you have a Minimorph?
Have you worked on this kind of platform before?
Sean.March 18, 2013 at 1:42 pm #36809
Thanks Seanr ,
I am doing for my own interest.
I have Minimorph ” Meta HTP 32 bit Xenif TZ`090 soc ” and FreeRTOS 7.4.0.
I have worked on OMAP4460 board with Kernel 3.0.31 and Jelly Bean.
But Here I dont know from where to start.
Thanks & Regards
SaurabhMarch 18, 2013 at 4:09 pm #36810
Documentation, distribution and tools to get up and running with Linux on the dev board are available on our website: https://www.imgtec.com/meta_insider/metaflow-sdk.asp
I have a suggestion, I’ll send you a message off-board.March 19, 2013 at 9:25 am #36811
I went through all the documents given by this link….
I am able to build MetaLinux
But Not FreeRTOS !!!!March 19, 2013 at 9:27 am #36812
Sure, I’ve emailed you on the address you registered with.April 4, 2013 at 5:18 am #36816
Which controller is used in Minimorph ” Meta HTP 32 bit Xenif TZ`090 .
It is Important for bringing up FreeRTOS.April 4, 2013 at 1:48 pm #36817
When you request information about the controller, which controller do you mean?April 4, 2013 at 2:51 pm #36818April 5, 2013 at 8:38 am #36819
I mean FreeRTOS supports 33 architectures.
located as FreeRTOS/Source/Portable/[compiler]/[architecture] sub directories
where [compiler] and [architecture] are the compiler used to create the port, and the architecture on which the port runs, respectively.
and I anm not able to find any arch there in FreeRTOS directory .
Is Minimorph HTP supprots FreeRTOS ?
Thanks again for TZ1090 TRM.
But I didnt get any TRM on this link.
Please send full path .
SAURABHApril 5, 2013 at 9:04 am #36820
FreeRTOS has not yet been ported to the Meta architecture so you will not find it there. It will be possible to port but will need additional hardware and debugging support to do JTAG level debug.
Click the METAFlow SDK link on that page for the downloads: https://www.imgtec.com/meta_insider/metaflow-sdk.asp