Question about POD file mesh instancing

This topic contains 1 reply, has 1 voice, and was last updated by  shawn19841006 6 years, 8 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #30498

    Hello world.

    I am using Collada2POD. When I convert a collada file, the output did show “Instancing mesh”, but when I read the .pod file I don’t get instancing, I still get the original number of meshes. Am I misunderstanding something?

    Thanks a lot.

    #34844

    Ok, so I found the answer myself. From coordinate system if you choose “World Space”, then identical meshes will not get instanced, only choose “Model Space” will do instancing. Seems pretty obvious but I just ignored that.

Viewing 2 posts - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.