Skybox Print3D

This topic contains 2 replies, has 2 voices, and was last updated by  alvalea 6 years, 11 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #30345

    alvalea
    Member

    Hi,

    I was playing with the SkyBox2 demo and I realized that if I comment the m_Print3D.Flush() statement, the skybox is not showed. Tough the ballon is still visible.

    Is there any dependence between cube_map textures and Print3D class?

    #34506

    Joe Davis
    Member

    Print3D sets a number of render states so that its draw calls execute correctly, but does not return them to their previous state afterwards. It sounds like the skybox render relies on one of these render states to be set. As the source code for our tools is provided in the SDK, it should be very straight forward to look though the Print3D code and determine which render state the skybox relies on 🙂

    #34507

    alvalea
    Member

    Ok, thanks. I’ll take a look on it 🙂

Viewing 3 posts - 1 through 3 (of 3 total)
You must be logged in to reply to this topic.