Strip Length Optimization

This topic contains 1 reply, has 2 voices, and was last updated by  Joe Davis 2 years, 11 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #31848

    Xteaphn
    Member

    I was looking through some documentation on an older chip and, saw that internally this PVR supports strip sizes of 1, 2, 4, and 6. Internally what is the benefit of setting the instruction word to support a strip size of 1 as opposed to a strip size of 6.

    I assume a strip size of 6 is faster for a large set of vertices. But if that were the case then in most cases you would want a strip size of 6, and a strip size of 2 for sprites. So when would it be advantageous to set a strip size of 1 or 4, and how important is it internally to set the strip size?

    #39069

    Joe Davis
    Member

    Hi,

    Can you clarify which GPU you’re referring to and which document you saw the recommendation in?

    Thanks,
    Joe

Viewing 2 posts - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.